Loop Antenna

[Admin 2427]

[Admin 2427]

The yagi-loop wireless antenna for wireless has built it in several variants and is remarkable for its low cost of construction, the ease of replication, but also the high gain and stability in operation.
The construction material used  is Cu wire type FY 4mm and FY 6mm, as well as glossy sheet from cans 0.2mm thick cut with 3.5mm strips.
Very good results are obtained with Cu FY 6mm, that is, a diameter of 2.6mm wire that you find at any DIY store

The materials are:
-Sarma With 6mm diameter 2.5mm 1.5m
- a cutting tool that does not leave burrs or deform the place of the cut.
-fludor and chlorophonium for bonding
- a relatively high power letcon, because With being massively absorbs strong heat (can not solder with a regular soldering gun)
A triangular fine pile used to create bookmarks on the CU string
- a solid cylinder with a diameter of about 33-35mm
-high quality coaxial cable, preferably H1000, h400, etc. with the necessary connectivity to the user (do not overdo the length of the cable, max 2m)

[Admin 2427]

And a variant of the antenna with flat-band brass...
 

 

http://www.paramowifix.net/antenas/loop_uda_yagi/index.html

[Admin 2427]

,,,biloop yagi on PCB...